This is the 2.4GHz Radio Controlled, Brushless Electric Powered
TxR (Transmitter Ready) Sensei Foam Trainer Airplane from Flyzone by Hobbico.
This is the Tx-R (Transmitter Ready) version that includes servos,
an ESC and SLT receiver.
With the AnyLink SLT 2.4GHz Radio Adapter (TACJ2000)
and the appropriate AnyLink cable
with compatible aircraft transmitter
4-channels or higher may be used to fly this airplane.
See Tx-Ready.com for full transmitter compatibility chart.
**Additional Technical Info Will Be Added When It Becomes Available.**
FEATURES: Construction: Aero-Cell foam with "drop door" in fuselage to deploy
a parachute or other creative payloads while in flight
Wings: Two piece
Aileron Control: Dual servo
Tail Section: Attaches with one screw and features self-aligning
stabilizer
Motor: Brushless, specs such as kV and RPM not provided by
manufacturer
Electronic Speed Control: 30A brushless compatible
Receiver: Tactic 2.4GHz SLT receiver
Servos: Five micro
Landing Gear: Main, prebent aluminum 0.098" (2.5mm) thick
Wheels: Three foam 2.5" (63.5mm)
Propeller: 10x5 plastic
Spinner: 1.75" (45mm) diameter black plastic
Warranty: Hobbico guarantees this kit to be free from defects in both
material and workmanship at the date of purchase. This warranty
does not cover any component parts damaged by use or modification.
INCLUDES: Sensei Foam Trainer Airplane with Motor ESC, five micro Servos, Prop,
Spinner, Landing Gear, Receiver, Wheels, and Instruction
Manual
REQUIRES: Tactic AnyLink SLT 2.4GHz Radio Adapter (TACJ2000) to adapt aircraft
transmitter (the Futaba Square, and JR, Spektrum,
are included with the AnyLink adapter)
*Tactic 2.4GHz 4 or 6 channel transmitters do not require the
AnyLink adapter
LiPo Battery: 2100mAh 11.1V,
Battery Charger: LiPo compatible w/balancing capability,
Pliers and phillips screwdriver
SPECS: Wingspan: 58" (1475mm)
Wing Area: 566 sq in (36.5 sq dm)
RTF Weight: 3.2lbs (1450g)
Length: 48" (1220mm)
Airfoil: Flat bottom
Configuration: High wing
Center of Gravity: Draw a mark 1/4" (7mm) back and 1/4" (7mm) forward
from the front of the aileron servo cover. The plane should
balance between these two marks.
Control Throws:
Elevator, Up/Down: 1/2" (15mm)
Rudder, Right/Left: 5/8" (16mm)
Ailerons, Up/Down: 1/2" (15mm)
